Using a FIBARO Implant to control a Garage Door

The FIBARO Implant and the Roller Limit Switch is the best way to Automate your Garage Door Using Z-wave
The IN1 terminal will be connected to the roller limit switch and the terminal OUT1 will be connected to the Garage door opener (GDO) terminals for a press button opener. Please use a separate power supply rather than powering off the GDO circuit board a 12v 1A power supply is sufficient and can usually be plugged into the power point feeding the GDO.
Can't find what you are looking for? Send us an email:
We are also on YouTube where we post many useful videos on our products
Back to blog

Leave a comment

Please note, comments need to be approved before they are published.