On this page you will find a Manual to install your new Oz Wifi Blinds and a fault finding guide
To access the manual on how to install your new Oz Smart Wifi Blinds, click the link below:
Attention Points:
The weight of the blinds that the motor has to pull is affected by several factors:
1. the length and the width of the blinds
2. the material of the blinds
3. how the blinds are installed (brackets being too tight may cause extra tension)
4. the blind type (roller blinds will be heavier than blinds that run in a track)
If the motor is not able to lift the blinds when the blinds are in the lowest position then you will need to use a spring assisted device.
https://www.blindpartsonlineaustralia.com.au/store/p114/Roller_Blind_Helper_Spring_%2F_Spring_Assist-_38mm%2C_43mm-_Acmeda.html
1 comment
Hi,
My controller does not have a on and off switch in the slit at the bottom. It is just a blank hole. Additionally there is not pin hole at the front. Therefore I am unable to use the device. Have you changed the design? If so, please advise me on how to operate it.