Product shipping info: We have Flat Rate Shipping of $10 per Order in Australia with 100% Carbon Neutral Courier Service and Eco Friendly Packaging (if available). We ship Worldwide for $20!
The QUBINO Z-Wave ON/OFF Thermostat (by GOAP) is ideal for directly controlling electric or water-based heating systems such as electric water heaters or hot water pumps.
- Z-Wave Plus certified
- Includes digital temperature sensor
- Can measure the power consumption of the connected device (within 3% accuracy)
- Extremely low energy consumption (less than 0.4W)
- Frost free mode: Specifies a minimum temperature for the heating system connected to the module to prevent your pipes from freezing
Product Details
The QUBINO Z-Wave ON/OFF Thermostat can be used to directly control electric or water-based underfloor heating systems, electric water heaters, hot water pumps, electric radiators and similar. You can control it either remotely through the Z-Wave network or through wall switches.
The QUBINO Z-Wave ON/OFF Thermostat also measures power consumption and supports the connection of a digital temperature sensor.
This product integrates with Australian certified (921.42 MHz) Z-Wave Controllers - Fibaro Home Center 2/Lite only
Note: It doesn't integrate with Vera gateways at this stage.
Configuring Z-Wave Devices:
Z-Wave devices often have several configurable parameters which you can change using your Vera’s user interface. These parameters can include things such as the length of time a Z-Wave siren remains active for or the type of manual switch connected to a Z-Wave light controller.
Every available configurable parameter is listed in your device’s user manual. In most cases, your device’s default parameters will be suitable to your needs however sometimes it may be necessary to adjust them to optimally use your device. A guide to configuring Z-Wave devices with Vera UI7 is available in the Manuals section.
Product Support
Manuals:
⇒ QUBINO Z-Wave ON/OFF Thermostat User Manual (Size: 397KB)
⇒QUBINO Z-Wave ON/OFF Thermostat Extended User Manual (Size: 3.64MB)
Videos / YouTube:
Technical Specifications
|
RF Protocol
|
Z‐Wave Plus (500 series chip)
|
|
RF Frequency
|
921.42Mhz ‐ AU/NZ approved RF for Z‐wave
|
|
Z‐Wave device type
|
Z-Wave binary switch, routing slave
|
|
Power Supply
|
230V AC ± 10% OR 24-30V DC
|
|
Rated Load Current of AC Output (resistive load)
|
1 x 10A / 230V AC
|
|
Rated Load Current of DC Output (resistive load)
|
1 x 10 A / 30V DC |
|
Output circuit power of AC output (resistive load)
|
2300W (230V AC) |
| Output circuit power of DC output (resistive load) | 240W (24V DC) |
|
Operation Range
|
Up to 30m indoors (with no obstacles)
|
|
Application
|
Indoor use only
|
|
Operation temperature
|
0 ~ 40 °C
|
|
Storage temperature
|
‐10 ~ 60 °C
|
|
Weight
|
48g
|
|
Dimensions
|
41.8mm x 36.8mm x 15.4mm
|